To Next Page

To Previous Page

Table 73: Edit RIP Global Settings (continued)

Your ActionFunctionField

Select True to allow any user to read the

file.

Select False to disallow all users being able

to read the file.

Specifies whether the trace file can be read by any user or

not.

World Readable

Select a value from the list.Specifies the tracing operation to perform.Flags

Documentation

Monitoring RIP Routing Information on page 212•

• Layer 3 Protocols Supported on EX Series Switches

Configuring Static Routing (J-Web Procedure)

You can use the J-Web interface to configure static routes for EX Series switches.

To configure static routes:

1. Select Configure > Routing > Static Routing. The Static Routing page displays details

of the configured routes.

NOTE: After you make changes to the configuration on this page, you

must commit the changes for them to take effect. To commit all changes

to the active configuration, select Commit Options > Commit. See Using

the Commit Options to Commit Configuration Changes for details about

all commit options.

2. Click one of the following options:

•

Add—To configure a route. Enter information into the routing page as described in

Table 74 on page 148.

•

Edit—To modify an existing route. Enter information into the routing page as

described in Table 74 on page 148.

•

Delete—To delete an existing route.

Table 74: Static Routing Configuration Summary

Your ActionFunctionField

Default Route

J-Web Application Package User Guide for EX Series Switches, Release 14.1X53-A1

Juniper EX Series User Manual

Other manuals for Juniper EX Series