• Example: Configuring CoS on EX Series Switches
Defining CoS Schedulers (J-Web Procedure)
NOTE: This topic applies only to the J-Web Application package.
J-Web Application package Release 14.1X53-A2 does not support Class of
Service (CoS) on EX4600 switches.
You can use the J-Web interface to define CoS schedulers on an EX Series switch. Using
schedulers, you can assign attributes to queues and thereby provide congestion control
for a particular class of traffic. These attributes include the amount of interface bandwidth,
memory buffer size, transmit rate, and schedule priority.
To configure schedulers:
1. Select Configure > Class of Service > Schedulers.
NOTE: After you make changes to the configuration on this page, you
must commit the changes immediately for them to take effect. To commit
all changes to the active configuration, select Commit Options > Commit.
See “Using the Commit Options to Commit Configuration Changes (J-Web
Procedure)” on page 31 for details about all commit options.
2. Select one of the following options:
•
Add—Adds a scheduler. Enter information into the Schedulers page as described
in Table 37 on page 69.
•
Edit—Modifies an existing scheduler. Enter information into the Schedulers page as
described in Table 37 on page 69.
•
Delete—Deletes an existing scheduler.
Table 37: Schedulers Configuration Page
Your ActionFunctionField
To name a scheduler, type the name—for
example, be-scheduler.
Specifies the name for a scheduler.Scheduler name
69Copyright © 2017, Juniper Networks, Inc.
Chapter 5: Class of Service Configuration
To Next Page
Loading...
Need help?
General
