CHAPTER 6
Security and Management Configuration
•
Configuring 802.1X Authentication (J-Web Procedure) on page 73
•
Configuring LLDP (J-Web Procedure) on page 76
•
Configuring Port Mirroring to Analyze Traffic (J-Web Procedure) on page 77
•
Configuring Port Security (J-Web Procedure) on page 80
Configuring 802.1X Authentication (J-Web Procedure)
NOTE: This topic applies only to the J-Web Application package.
J-Web Application package Release 14.1X53-A2 does not support 802.1X
authentication on EX4600 switches.
To configure 802.1X settings on an EX Series switch using the J-Web interface:
1. Select Configure > Security > 802.1X.
The 802.1X screen displays a list of interfaces, whether 802.1X security has been
enabled, and the assigned port role.
When you select an interface, the Details of 802.1xconfiguration on port section displays
802.1X details for that interface.
NOTE: After you make changes to the configuration on this page, you
must commit the changes for them to take effect. To commit all changes
to the active configuration, select Commit Options > Commit. See Using
the Commit Options to Commit Configuration Changes for details about
all commit options.
2. Select one of the following options:
73Copyright © 2017, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
