Juniper EX Series User Manual

Table 74: Static Routing Configuration Summary (continued)
Your ActionFunctionField
To specify an IPv4 address:
1. Select IPv4.
2. Type an IP address—for example,
10.10.10.10.
3. Enter the subnet mask or address prefix.
For example, 24 bits represents
255.255.255.0.
To specify an IPv6 address:
1. Select IPv6.
2. Type an IP address—
for example,
2001:ab8:85a3::8a2e:370:7334.
3. Enter the subnet mask or address prefix.
Specifies the default gateway for the
switch.
NOTE: IPv6 is not supported on
EX2200 and EX4500 switches.
Default Route
Static Routes
To add an address:
1. Click Add.
2. In the IP address dialog, enter the IP
address.
NOTE: If a route has multiple next-hop
addresses, traffic is routed across each
address in round-robin fashion.
3. Click OK.
To delete a next-hop address, select it from
the list and click Delete.
Specifies the next-hop address or
addresses to be used when routing
traffic to the static route.
Nexthop
Related
Documentation
• Configuring Static Routing (CLI Procedure)
• Monitoring Routing Information on page 215
• Layer 3 Protocols Supported on EX Series Switches
149Copyright © 2017, Juniper Networks, Inc.
Chapter 11: Configuring Layer 3 Protocols

Juniper EX Series Specifications

General

Brand	Juniper
Model	EX Series
Category	Switch
Language	English