Keithley 3700A Series Reference Manual

Section 9: Introduction to TSP operation Series 3700A System Switch/Multimeter Reference Manual
9-32 3700AS-901-01 Rev. D/June 2018
Saved setups
Use the saved setups commands to save or restore the configurations to or from the nonvolatile
memory of the instrument or an installed USB flash drive. You can use the setup.poweron attribute
to specify which setup is recalled when the instrument is turned on.
createconfigscript() (on page 11-110)
setup.cards() (on page 11-354)
setup.poweron (on page 11-355)
setup.recall() (on page 11-356)
setup.save() (on page 11-356)
Scan
The scan functions and attributes allow you to set up scanning over the remove interface.
scan.abort() (on page 11-308)
scan.add() (on page 11-309)
scan.addimagestep() (on page 11-311)
scan.addwrite() (on page 11-312)
scan.background() (on page 11-313)
scan.bypass (on page 11-314)
scan.create() (on page 11-315)
scan.execute() (on page 11-317)
scan.list() (on page 11-318)
scan.measurecount (on page 11-320)
scan.mode (on page 11-321)
scan.nobufferbackground() (on page 11-322)
scan.nobufferexecute() (on page 11-323)
scan.reset() (on page 11-324)
scan.scancount (on page 11-325)
scan.state() (on page 11-326)
scan.stepcount (on page 11-327)
scan.trigger.arm.clear() (on page 11-327)
scan.trigger.arm.set() (on page 11-328)
scan.trigger.arm.stimulus (on page 11-328)
scan.trigger.channel.clear() (on page 11-330)
scan.trigger.channel.set() (on page 11-330)
scan.trigger.channel.stimulus (on page 11-331)
scan.trigger.clear() (on page 11-332)
scan.trigger.measure.clear() (on page 11-333)
scan.trigger.measure.set() (on page 11-333)
scan.trigger.measure.stimulus (on page 11-334)
scan.trigger.sequence.clear() (on page 11-335)
scan.trigger.sequence.set() (on page 11-336)
scan.trigger.sequence.stimulus (on page 11-336)

Keithley 3700A Series Specifications

General

Brand	Keithley
Model	3700A Series
Category	Multimeter
Language	English