Keithley 3700A Series Reference Manual

Section 11: TSP command reference Series 3700A System Switch/Multimeter Reference Manual
11-158 3700AS-901-01 Rev. D/June 2018
Details
This command saves the calibration constants and adjustment date and increases the adjustment
count by 1. The adjustment count is the number of times calibration has been saved.
This command does not check for errors in calibration data. Calibration data is saved regardless of
calibration data errors.
The calibration date can be specified with dmm.adjustment.date. If it is not specified, the date is
based on the system date.
To prevent data loss, you need to send the save command before locking calibration.
An error is generated if this command is issued when calibration is already locked.
Example
dmm.calibration.save()
Saves calibration data.
Also see
dmm.adjustment.date (on page 11-144)
dmm.calibration.lock() (on page 11-156)
dmm.calibration.unlock() (on page 11-158)
dmm.calibration.unlock()
This function unlocks calibration if calibration was locked.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
Yes
Usage
dmm.calibration.unlock("password")
password
A string representing the password to unlock calibration
Details
If the password does not match the saved password, an error is generated. The default password
from the factory is "KI003706". You can change the default with dmm.calibration.password.
Example
dmm.calibration.unlock("KI003706")
Unlocks calibration using the default
password.
Also see
dmm.calibration.lock() (on page 11-156)
dmm.calibration.password (on page 11-157)

Keithley 3700A Series Specifications

General

Brand	Keithley
Model	3700A Series
Category	Multimeter
Language	English