Lenze i550 Series Project Planning Manual

Product informaon
Product descripon
i500 is the new inverter series - a streamlined design, scalable funconality and exceponal
user-friendliness.
The funconal safety describes the necessary measures that need to be taken by means of
electrical or electronic equipment to prevent or eliminate dangers due to funconal errors.
Protecve devices prevent any human access to dangerous areas during normal operaon.
However, persons may have to be in the danger areas in certain operang modes. The
machine operator is protected by internal drive and control measures in these operang
modes
Integrated safety
The integrated safety technology fulls the control and drive condions for implemenng the
protecve funcons. The expenses for planning and installaon decrease. The machine func-
onality and availability increases thanks to the use of integrated safety technology. The inte-
grated safety technology is applicable for protecng personnel working with machines in
accordance with the Machinery Direcve.
The moon funcons connue to be executed by the inverter. The integrated safety system
monitors the safe compliance with the limit values and provides the safe inputs. If monitored
limit values are exceeded, the integrated safety system iniates control funcons in the inver-
ter to counteract possible errors according to EN 61800−5−2.
i500 is a high-quality inverter that already conforms to future standard in accordance with the
EN 50598-2 eciency classes (IE). Overall, this provides a reliable and future-proof drive for a
wide range of machine applicaons.
The i550
This chapter provides the complete scope of the inverter i550. This inverter is suitable for a
very broad use in inverter-operated drives. Basically, the device has the following features:
•
All typical motor control types of modern inverters.
•
Cyclic and connuous operaon of the motor according to common operang modes.
•
Industry-standard networking opportunies.
•
High internal funconal range.
Highlights
•
Compact size
-
Up to 2.2 kW only 60 mm wide
-
Up to 11 kW only 130 mm deep
•
Can be directly connected without external cooling
•
Innovave interacon opons enable beer set-up mes than ever.
•
The wide-ranging modular system enables various product conguraons depending on
machine requirements.
Product informaon
10

Lenze i550 Series Specifications

General

Protection Class	IP20
Ambient Temperature	-10°C to +50°C
Overload Capacity	150% for 60 seconds
Control Type	Vector control
Communication Interfaces	CANopen, Modbus, Ethernet, PROFIBUS, PROFINET
Safety	STO (Safe Torque Off)
Frequency Range	0 Hz
Cooling Method	Air cooling
Storage Temperature Range	-25°C to +70°C
Input Voltage Range	3-phase 380...480 V AC -15%/+10%