Lenze i550 Series Project Planning Manual

Applicaon as directed
•
The product must only be operated under the operang condions prescribed in this doc-
umentaon.
•
The product meets the protecon requirements of 2014/35/EU: Low-Voltage Direcve.
•
The product is not a machine in terms of 2006/42/EC: Machinery Direcve.
•
Commissioning or starng the operaon as directed of a machine with the product is not
permied unl it has been ensured that the machine meets the regulaons of the EC
Direcve 2006/42/EC: Machinery Direcve; observe EN 60204−1.
•
Commissioning or starng operaon as directed is only permissible if the EMC Direcve
2014/30/EU is complied with.
•
The harmonised standard EN 61800−5−1 is applied.
•
The product is not a household appliance, but is only designed as a component for com-
mercial or professional use in terms of EN 61000−3−2.
•
The product can be used according to the technical data if drive systems have to comply
with categories according to EN 61800−3.
In residenal areas, the product may cause EMC interferences. The operator is responsible
for taking interference suppression measures.
•
The product must only be actuated with motors that are suitable for the operaon with
inverters.
-
Lenze L-force motors meet the requirements
-
Excepon: m240 motors are designed for mains operaon only.
The user is not allowed to change inverters that come with integrated safety technology.
The safety module must not be removed. If the safety module is defecve, the inverter has to
be replaced.
Informaon on project planning
Safety instrucons
Applicaon as directed
34

Lenze i550 Series Specifications

General

Protection Class	IP20
Ambient Temperature	-10°C to +50°C
Overload Capacity	150% for 60 seconds
Control Type	Vector control
Communication Interfaces	CANopen, Modbus, Ethernet, PROFIBUS, PROFINET
Safety	STO (Safe Torque Off)
Frequency Range	0 Hz
Cooling Method	Air cooling
Storage Temperature Range	-25°C to +70°C
Input Voltage Range	3-phase 380...480 V AC -15%/+10%