Lenze L-force 8400 BaseLine D User Manual

Firmware 03.00 - DMS EN 5.0 - 07/2009 L 35
8400 BaseLine D | Software Manual
Commissioning
Commissioning of the drive application with the »Engineer«
3.4.3 Load the Lenze setting
In order to be able to take a defined state as a basis for this commissioning, you have to
load the Lenze setting.
Start the action with C002/1
=1.
 Tip!
How to load the Lenze setting using the »Engineer« is described in chapter Load
Lenze setting ( 58).
3.4.4 Make motor settings
Enter the data of your motor into the field marked with the arrow if it is not a power-
adapted standard motor:
 Note!
After the Lenze setting has been loaded, the "action ready" status is reported
with C002/1
=0.

Lenze L-force 8400 BaseLine D Specifications

General

Brand	Lenze
Model	L-force 8400 BaseLine D
Category	Inverter Drive
Language	English