Lenze L-force 8400 BaseLine D User Manual

8400 BaseLine D | Software Manual
About this documentation
Document history
8 L Firmware 03.00 - DMS EN 5.0 - 07/2009
1 About this documentation
This Software Manual contains information about the parameterisation of the
8400 BaseLine D controller using the L-force »Engineer« and the keypad.
The information given in this Software Manual applies to the 8400 BaseLine D frequency
inverter with the following nameplate data:
 Tip!
Current documentation and software updates for Lenze products can be found on
the Internet in the "Services & Downloads" area under
http://www.Lenze.com
1.1 Document history
 Danger!
The controller is a source of danger which may lead to death or severe injury of
persons.
To protect yourself and others against these dangers, observe the safety
instructions before switching on the controller.
Please read the safety instructions provided in the 8400 Mounting Instructions
and in the 8400 Hardware Manual. Both documents are supplied with the
controller.
Type Type designation From software
version
Important
8400 BaseLine D E84AVBDExxxxSX0 2.1 Variant without digital output X4/DO1
8400 BaseLine D E84AVBDExxxxSX1 2.1 Variant with digital output X4/DO1
Digital outputs
( 118)
8400 BaseLine D E84AVBDExxxxxx0 3.0 New function block L_PCTRL
Version Description
1.0 06/2008 TD06 First edition
2.0 07/2008 TD 06 Second edition
3.0 02/2009 TD 06 New: The chapters "Commissioning" and "Parameter reference" have been revised,
new block L_RLQ (CW/CCW rotation)
4.0 04/2009 TD 06 New: Subcode c012 in C002 for adaption of parameter sets from controllers with
firmware version ≤ V2.1 in the event of service.
5.0 04/2009 TD 06 New:
• Function block L_PCTRL
• Quick saving at the push of a button
( 59)
• Parameter list with info texts

Lenze L-force 8400 BaseLine D Specifications

General

Brand	Lenze
Model	L-force 8400 BaseLine D
Category	Inverter Drive
Language	English