MMX8x4-HT series – User's Manual 55
Install and Upgrade
Installation for Windows OS
ATTENTION! The minimum display resolution shall be 1280x720.
Step 1.
Step 2. During the installation you will be prompted to select the type of the installation: normal and the
snapshot install:
Normal install Snapshot install
The installer can update only this
instance
Cannot be updated
Only one updateable instance can
exist for all users
Different versions can be
installed for all users
Comparison of the Installation Types
ATTENTION! Using the Normal install as the default value is highly recommended.
Installation for macOS
INFO:
version with the same attributes.
over the desired folder.
ATTENTION!
exceptions of the blocked software for the proper operation.
The Upgrading of the LDC
Step 1. Run the application.
The Device Discovery window appears automatically and the program checks the available updates on
version number can be seen at the top of the window and they are shown in this window even with the
snapshot install. The Update window can also be opened by clicking the About icon and the Update button.
Step 2. Set the desired update setting in the Options section.
▪ If you do not want to check for the updates automatically, uncheck the circle, which contains the green
tick.
▪ If you want to postpone the update, a reminder can be set with different delays from the drop down list.
▪ If the proxy settings traverse the update process, set the proper values then click the OK button.
Step 3. Click the Download update button to start the upgrading.
The updates can be checked manually by clicking the Check now button.
Running the LDC
The common way to start the software is double-click on
parameters as follows:
Connecting to a Device with Static IP Address
IP address directly; the Device Discovery window is not
the 6107 port number.
Format: LightwareDeviceController -i <IP_address>:<port>
Example: LightwareDeviceController -i 192.168.0.20:6107
Connecting to a Device via a Serial Port
displayed. If no Baud rate is set the application will detect it automatically.
Format: LightwareDeviceController -c <COM_port>:<Baud>
Example: LightwareDeviceController -c COM1:57600
Adjusting the Zoom
default value (100%).
Format: LightwareDeviceController -z <magnifying_value>
Example: LightwareDeviceController -z 1.2
ATTENTION!
To Next Page
Loading...
Need help?
General
