MMX8x4-HT series – User's Manual 80
Infra Tab
ATTENTION! The device has no built-in Infrared transmitter. For the complete usage attach an IR emitter
unit to the IR OUT connector. #infra#infrared
Infra tab in the Control menu
All the infra ports are transmitters and they are able to forward the Infra message, which comes from the
Control Ethernet port (the operation mode is always Command Injection).
The following settings are also available:
▪ Port name
▪
▪ Port number
▪
▪ Message sending function (little-endian prontohex code) For more details see the Sending Pronto Hex
section. #message
▪ Reloading factory defaults (see factory default settings in the Factory Default Settings section).
USB Switch Tab
DIFFERENCE: Only MMX8x8-HDMI-4K-A-USB20 model has this Tab. #new
The following settings are available:
▪
One host can be active at the same time from the four.
▪ Enable the Power Switch Delay: After switching the hosts (on USB-B ports), this feature
automatically for 2 seconds of all devices (on USB-A ports).
INFO: After switching between the hosts, some connected USB device needs reset to operate properly
for 2s, and the device restarts.
▪ Host5vSensePc gives feedback about the connected hosts.
▪ #usb
To Next Page
Loading...
Need help?
General
