DRIVE ENCRYPTION & DECRYPTION
Logicube Falcon
®
-Neo User’s Manual 104
7.1.1 Step-By-Step Instructions
1. Select System Settings from the types of operation on the left side.
2. Tap the Encryption tab.
3. Set the Cipher Mode, Cipher, IV Generation, and Password.
4. Select Wipe from the types of operation on the left side.
5. Tap the Destination icon and select the Destination drive to be formatted and
encrypted.
6. Tap the Settings icon.
7. Tap the Format Settings icon to change the Format setting.
a. Set Format to ON.
b. Select the desired File System (EXT4, NTFS, exFAT, or FAT32).
c. Set Encryption to ON. When finished, tap the OK icon.
8. Tap the Start icon to start the wipe task. The Falcon-NEO will format the selected
drive(s) with encryption.
7.1.2 Using Previously Encrypted Destination Drives
If a previously encrypted Destination drive is going to be used and the Falcon-NEO has
been turned off since the last time the encrypted drive was used, the encryption settings
must be set with the same encryption settings previously used before connecting the
drive.
If the same encryption settings are commonly used, the
encryption settings and configuration can be saved as a profile,
so they do not have to be entered manually all the time.
1. Make sure the previously encrypted Destination drive is not connected, then turn
the Falcon-NEO on.
2. From the main menu, select System Settings from the types of operations on the
left side.
To Next Page
Loading...
Need help?
General
