Logicube Falcon-NEO User Manual

REMOTE OPERATION
Logicube Falcon
®
-Neo User’s Manual 122
1. Using one of the RJ45 connectors in the back of the Falcon-NEO, connect the
Falcon-NEO to a network.
2. Turn the Falcon-NEO on and allow it to boot up completely.
3. Open the SSH client and select an SSH connection.
4. Connect to the Falcon-NEO either by IP address or by hostname. The name of the
Falcon-NEO will be falcon-XXXXXX where XXXXXX is the 6-digit serial number of
the Falcon-NEO).
On some Operating Systems, the
Falcon-NEO will need to be accessed
by opening falcon-XXXXXX.local.
5. Login with the username “it” (without the quotes) and the password “it” (without
the quotes). A command prompt should appear in the SSH window.
Use the it login in step 5. It is not recommended to
use the logicube account login without consulting
with Logicube Technical Support prior to use.
The Falcon-NEO can now be configured or managed via the command line interface.
9.3 Zero Configuration Networking (Zeroconf)
The Falcon-NEO has the capabilities for Zero Configuration Networking (Zeroconf). Zeroconf allows
devices to automatically create a usable computer network based on the Internet Protocol Suite (TCP/IP).
For example, when the Falcon-NEO is connected (using a network cable) directly to a Windows based
computer that is DHCP enabled, both the Falcon-NEO and the Windows based computer will
automatically configure themselves to be seen by each other using TCP/IP with a 169.254.x.x IP address
configuration.
9.4 Copying Profiles from One Falcon-NEO to Another
Profiles can be copied from one Falcon-Neo to another using the Command Line Interface (CLI). The
Falcon-NEO units must be on the same network and all Profiles will be copied. Instead of configuring each
Falcon-Neo one at a time, all Falcon-Neo units can have the same profiles with a few simple commands.
9.4.1 Step-By-Step – Copying Profiles
Once the profiles are configured and saved onto a Falcon-NEO:
1. Connect the Falcon-NEO with the saved profiles and any additional Falcon-NEO units
to a network.
2. Using Telnet or SSH, connect to the Falcon-NEO that has the profiles saved (See
Section 9.2.1 and Section 9.2.2 for more information on connecting using Telnet or
SSH).

Logicube Falcon-NEO Specifications

General

Brand	Logicube
Model	Falcon-NEO
Category	Laboratory Equipment
Language	English