6 - 34 Operator’s Manual
6 Image Acquisition
2. Tap [iWorks] on the touch screen or press the user-defined key for “iWorks” to enter the
protocol selection screen, and tap the corresponding protocol button to enter the status.
After the system enters the iWorks screen, the available protocol is displayed on the right of
the screen.
3. Perform the scanning and saving according to the screen prompt.
4. Perform measurements or add comments/body marks to the image according to the screen
prompt.
5. After a view scanning is complete, press the user-defined save key to switch to the next view
according to the screen prompt.
6. Repeat steps 3 to 5 to acquire all the necessary images.
– If a pathology is discovered, tap [Insert] to select a protocol outside of the normal routine
to start scanning.
– Tap [Repeat] to add a copy of the selected view to work on if necessary.
– Tap [Next] or [Previous] to skip to a particular view you are interested in.
– Tap [Replace] to delete images and operations for the selected view and restart operations
on that view.
– Tap [Delete] to delete the currently activated view.
– Tap [Suspend] to start a manual scan when an unusual or atypical workflow is required,
and tap [Resume iWorks] to restart the iWorks procedure.
7. After all views are finished, the system will prompt you to exit iWorks. Tap [Yes] to exit.
6.16.1 Screen Display
Monitor Display
The monitor displays the following screen:
1 Displays the protocol name, and the number of views contained.
To Next Page
Loading...
Need help?
General
