Mindray ME8 Operator's Manual

4 - 18 Operator’s Manual
4 Setup
4.3.1 General Measurement Preset
You can preset the General Measurement packages for 2D (B/Color/Power Mode), M Mode, or
Doppler (PW/CW) Mode respectively.
Perform the following procedure:
1. Select the [Caliper] on the [Measure] page.
2. Select the [2D], [M] or [Doppler] tab to go to the corresponding preset menu.
– [Available Items]: general measurement tools configured by the system in the current
scanning mode which are available but not assigned yet.
– [Selected Items]: displays the tools to be added to the menu.
3. Add/Remove the general measurement item using the following buttons:
– [>]: To add the selected tool from the [Available Items] to the [Selected Items].
– [>>]: To add all tools in the [Available Items] to the [Selected Items].
– [<]: To remove the selected tool from the [Selected Items] to the [Available Items].
– [<<]: To remove all tools from the [Selected Items] to the [Available Items]. You do not
need to select any items before removing.
4. Set the default item.
Select an item from the [Selected Items], then click [Default]. The item is marked with a √.
The default item is activated automatically when entering this general measurement menu.
5. Adjust the item position.
Select an item from the right column and click [Up]/[Down] to adjust the sequence in which
the items are arranged in the corresponding general measurement menu (touch screen display).
6. Modify the properties of a measurement item.
The following takes D trace as an example to show how to set the properties of a measurement
tool.
a. Select the [Doppler] tab to go to the corresponding preset menu.
b. Select [D Trace] from the [Selected Items] and click [Property] to bring up the following
dialog box.

Mindray ME8 Specifications

General

Brand	Mindray
Model	ME8
Category	Diagnostic Equipment
Language	English