To Next Page

To Previous Page

3 System Preparation

Operator’s Manual 3 - 3

• There is no condensation.

• There is no distortion, damage or dirt on the system and peripheral devices.

If any dirt is found, cleaning shall be performed, see “18 System Maintenance”.

• There are no loose screws on the monitor, control panel or the trolley.

• There is no cable damage (e.g., power cord). Maintain secure connections to the system at all

times.

• The probes and probe cables are free from damage or stains.

For details of probe cleaning and disinfection, see “16.1.5 Probes Cleaning and Disinfection”.

• No miscellaneous odds and ends are attached or affixed to the control panel.

• Ensure that all connections are free from damage and remain clear of foreign object blockages.

There are no obstacles around the system and its air vent.

• Probe cleaning and disinfection.

• The entire scanning environment and field must be clean.

• The locking mechanism of the casters (if there is a trolley) works normally.

3.3.2 Power the System ON

Press the power button to power the system on.

If access control has been set by the system administrator, you can access data in the system only

after logging onto the system. For details, see “4.1.10 Access Control”.

You must log in again after system restart or dormancy.

To login onto the system

Perform the following procedure:

1. Select the login type (Local or LDAP), and user name in the drop-down list.

2. Enter the password and click [Login].

When the user has logged onto the system, is visible in the bottom-right corner of the

screen.

To change users

Perform the following procedure:

1. To log out the current user and change to another user, click in the bottom-right corner of

the screen to bring up the following dialog box

2. Click [Change User] to bring up the Login dialog box.

3. Select the login type, and user name in the drop-down list.

4. Enter the password and click [Login].

To modify password

General operators and administrators can modify the password.

Perform the following procedure:

Mindray ME8 Operator's Manual

Other manuals for Mindray ME8