18 - 2 Operator’s Manual
18 System Maintenance
Do not spill water or other liquid into the system while you perform the cleaning.
Otherwise it may result in malfunction or electric shock.
• DO NOT use hydrocarbon glass cleaner or cleaner for OA (Office Automation) equipment to
clean the monitor. These substances may cause deterioration of the monitor.
• Please clean the control panel periodically, otherwise the button may be blocked by dirt and the
system will be buzzing while the button makes no response.
Cleaning probes
Tools: mild soapy water, dry soft cloth, soft brush
Method:
1. Wipe out the dust attached to surface of probe head, connector and cable.
2. Use soft brush to brush the dust inside probe connector gently.
3. Remained stain or dust attached to surface of cable or surface of connector should be washed
out by cloth with a little soapy water, and then air-dry.
Don’t use cloth with water to clean the probe connector.
Cleaning holders
Tools: soft dry cloth, soapy water, soft brush.
Remaining stains should be wiped away using a cloth with clean or soapy water and the surface left
to air dry.
Perform the following procedure:
1. Use a soft dry cloth to wipe away dust attached to the inside, outside and gaps in the probe
holder. Use a soft brush to brush away dust or stains from the small intra-cavity probe holder or
its gap.
2. Remaining stains on the inside and outside of the holder should be wiped away using a cloth
with a little soapy water and then air dried.
Cleaning the monitor and the touch screen
Tool: soft dry cloth, soapy water
The surfaces of the monitor and touch screen should be cleaned with a soft dry cloth. Remaining
stains should be wiped away using a cloth with a little soapy water and then air dried.
Cleaning the main panel
Tools: soft dry cloth, soapy water
1. Use a soft dry cloth to clean the surface of the control panel.
If the control panel is dirty, moisten the soft cloth with a little mild soapy water and wipe away
any stains.
2. Use another soft dry cloth to remove any moisture and allow all hard surfaces to completely air
dry.
To Next Page
Loading...
Need help?
General
