A Barcode Reader
Operator’s Manual A - 11
3. When the digital imager reader senses movement, in its default Auto Aim trigger mode, it
projects a red LED dot which allows positioning the barcode within the field of view.
If necessary, the digital imager reader turns on its red LEDs to illuminate the target barcode.
4. Center the symbol. Be sure the entire symbol is within the rectangular area formed by the
illumination LEDs.
5. Hold the trigger until the digital imager reader beeps, indicating the barcode is successfully
decoded.
Steps 2 - 4 above may be required to repeat on poor quality or difficult barcodes.
The aiming pattern is smaller when the digital imager reader is closer to the symbol and larger
when it is farther from the symbol. Scan symbols with smaller bars or elements (mil size)
closer to the digital imager reader, and those with larger bars or elements (mil size) farther
from the digital imager reader.
The digital imager reader can also read a barcode presented within the aiming dot not centered.
The top examples in show acceptable aiming options, while the bottom examples cannot be
decoded.
To Next Page
Loading...
Need help?
General
