3Explanation of operation methods
Programming 3-37
(3) Completion of program creation and saving programs
If the function key which corresponds for "CLOSE" is pressed, the program will be saved and creation will be
finished.
If the "CLOSE" is not indicated, press the [FUNCTION] key, and display it.
<PROGRAM> 1 50%
1 Mov P1
2 Mov P2
3 End
CLOSE123
CHANGE
DIRECT
⇒
Save & exit of the program [F4]
<FILE/EDIT> 1/20 Rem 136320
1 08-04-24 17:20:32 22490
2 08-04-24 14:56:08 694
A1 08-04-24 13:05:54 2208
B1 08-04-24 13:05:54 1851
COPY
123
POSI.
EDIT
NEW
⇒
Precautions when saving programs
Make sure to perform the operation above. The edited data will not be updated if the power is turned off
without doing so after modifying a program on the program edit screen. Moreover, as much as possible, try
to save programs not only on the controller but also on a PC in order to make backup copies of your
work.It is recommended to manage programs using RT ToolBox 2 (optional).
To Next Page
Loading...
Need help?
General
