Motorola Razr V3x Personalization Guide (MoGu V3xPG) V2.5
(Volume 1 - Primary Mods)
V3X Personalization Guide-V2-5-eb-v1-061205.doc 65 of 227
ebentley
e boxes without any difficulty. In fact, both of my V3x(s) are set
that way right now. I just did a quick tutorial (MS Word file and flash file) on changing those settings. So, if I'm telling
[ebentley] @alsitin: I've tried it with zeroes in all thre
people something wrong, please let me know so I can change the tutorials.
[EDIT]: Just checked my SMS send capability and alsitn is right (as usual
) Setting the SMS size to zero (0)
prevents you from sending SMS messages. When you try to send, you get a message that says "you've exceeded f
limit". I just set it back to 1MB and
ile
it now works fine. I'll correct the tutorials and re-post. [End Edit].
Settings>Video Camera>Options>Video Camera Setup
• Auto Repeat: Off
• Full Screen: Left (90 CCW)
• Spatial Audio: On
• Spatial Width Control: 7
• Bass Boots: On
• Bass Boost Level: 7
• Video Quality: Best
• Video Length: Maximum (this will allow you to capture video for as long as you
have space on your card)
Basically, here’s what I know about the V3x’s MMS video capabilities operating on the Cingular network in
the US:
Table 8 - V3x MMS Capabilities on Cingular
V3x Capability On Cingular Result/Message
Send MMS containing video attachment
-To another video capable handset
-To a mobile email account
-To a non-mobile email account
Yes
Successful
Receive Video attachment in MMS from
another handset
Yes: Receive MMS text
“One or more of the message
components have been deleted by
MMS Adaptation. Either the
message was too large or the
ts were unsuitable for your
terminal.”
No - not the video
attachment
componen
Receive Video attachment in email sent to my
mobile email account
XXXXXXXXXX@mobile.m
Yes: Receive MMS text
No - not the video
Unsuccessful
ycingular.com
attachment
1.28 Correcting Browser Errors after Firmware Flashes
Sometimes, after flashing with new firmware, the browser has a hard time displaying proper graphics and text. Here’
iggy822]: Hi guys.
atest generic firmware. The symptoms I am getting are, the
mbols instead of the usual graphics and text. I have the correct
what you need to do to correct this problem.
Problem: [Sh
I recently Flashed my firmware from 3 (AUS) to the l
w ole page coming up with square character syh
obr wser settings, I have deleted the web sessions file from /a/ and set it up again etc. I have also reflashed my phone
with the same generic firmware, but still getting the same output. I'm thinking about flashing back to a 3 (Australia)
firmware if there's no way around this.
To Next Page
Loading...
Need help?
General
