Motorola Razr V3x Personalization Guide (MoGu V3xPG) V2.5
(Volume 1 - Primary Mods)
V3X Personalization Guide-V2-5-eb-v1-061205.doc 68 of 227
ebentley
correctly into the handset or not. Also make sure that the phone is fully
ersonal Identification Number) is a security feature of your SIM card. It is given when you connect to a
IN an prevent your mobile phone number from being used if it is lost or stolen. If you wish
activate your PIN or change it you can do so by using the security feature on your phone.
ntered incorrectly three times.
t PUK three times can permanently block the SIM Card in your phone.
get my phone unblocked?
service provider to get the unblocking code.
n HTTP)
re working fine for t-mobile till a few days ago. I
s and the part where you are supposed to set up the phone (Service Types 1 & 2) as WAP wont let
TTP or HTTP Secure. I already erased the web sessions and tried again. Any suggestions? My
RIUSEMEAR25221_095 R252211LD_U_85.9a.80
eed to write down all the
EDIT what you mean, It
TP or HTTP Secure as choices so let me look into this right now.[END EDIT]
e quick looking I determined that the problem resides in the flex settings. My Silver V3x
service type options under Service Types 1 & 2. The Black V3x didn't. It only provided the HTTP
ecure options yet both are running 85.9A.80R (Reflash) using the H3G flex. As part of the troubleshooting,
ere I
resented with only the HTTP options. So the problem had to lie elsewhere. turns out it was in the flexes. I
d completely different flex (settings) installed on each phone. I uploaded my Baseline flex file that I knew provided
r Service types and always works to the Black V3x and voila--I got all the options back as
ollowing cell screen capture.:
Please check if the Sim Card is inserted
charged. It may take upto 14 to 16 hrs for your phone to be fully charged for the first time.
What is the use of PIN ?
The PIN (P
network. Activating your P c
to
What is PUK?
PUK is Personal Unblocking Code. It is required when a security PIN has been e
Entering an incorrec
Who do I contact to
You must contact your
1.31 Web/MMS Setting Help (No Service Type 1&2 Menu Options other tha
Problem: [
uscolmrne] My picture messaging and web browser we
checked the setting
me, I can only input H
firmware info is UCSI
[ebentley] If you backed up your websession file, then upload it again and then copy it. No n
settings. You can then amend it at will. [ ] Hold on! I just took another look at mine and I see
only allows me to enter HT
[ebentley] Update: After som
provided me all the
and HTTP S
I took the good web session file from the Silver V3x (the one with all the options) and copied it to my Black V3x. wh
was still p
ha
me the additional options fo
you can see in the f
To Next Page
Loading...
Need help?
General
