Native Instruments Maschine MIKRO User Manual

▪ A modulation track is created for this parameter in the Modulation pane of the Control area
(at the bottom of the Pattern Editor) containing the modulation points you have just record-
ed. You can further edit the modulation track from there — see section ↑7.5.3, Creating
and Editing Modulation in the Control Lane.
Removing Modulation
You can also use the outer ring to remove the entire modulation for the knob:
►
To remove the entire modulation for a knob, simply right-click (on Mac OS X: [Ctrl]+click)
its outer ring.
You can also create and edit modulation tracks directly in the Control Lane. See section
↑7.2.2, The Record Prepare Mode for more information.
To modulate a parameter with the controller:
1. Press the CONTROL button to enter Control mode.
2. Make sure the song is playing (PLAY must be lit).
3. Navigate to the parameter you want to modulate. To do this, put the focus on the desired
Group or Sound (see ↑2.3.1, Setting the Focus on a Group or a Sound), navigate to the
desired Plug-in or set of Channel properties, and finally to the Parameter page and the
particular parameter (see ↑2.3.4, Navigating Channel Properties, Plug-ins, and Parameter
Pages in the Control Area).
4. Hold SHIFT to enter Auto-write mode.
At the bottom of the display, if the parameter is not modulatable its value disappears. If
the parameter is modulatable and continuous its value is replaced by a percentage.
5. While holding SHIFT, turn the Control encoder.
→
Your modulation gets recorded now. Each encoder movement is stored in your Pattern as
an modulation event. It will be automatically played with your Pattern upon its next cycle.
From your controller you can also delete all modulation events for all parameters of the chan-
nel:
Working with Patterns
Recording and Editing Modulation
MASCHINE MIKRO - Manual - 368

Native Instruments Maschine MIKRO Specifications

General

Brand	Native Instruments
Model	Maschine MIKRO
Category	Telephone
Language	English