The Aux page of the Output properties (here for a Group) in the software.
The AUX page of the Output properties (here for a Group) on the controller.
Please refer to section ↑2.3.4, Navigating Channel Properties, Plug-ins, and Parameter
Pages in the Control Area to know how to access the Aux page of the Output properties
in the software and from your controller.
Controls Description
AUX 1 / AUX 2 Section
Dest. Selects where you want to send the Aux 1 or Aux 2 output of your
channel. Available options are the same as for the Dest. selector of
the Audio page (see ↑8.1.2, Configuring the Main Output of Sounds
and Groups), except that for Aux 1 and Aux 2 the default
destination is None — in other terms there are no auxiliary sends
defined by default.
Level Adjusts the level of the signal sent to the Aux 1 or Aux 2 output.
Order If Order is set to Pre, the channel will be fed into Aux 1 or Aux 2
before the Level and Pan settings of the MAIN section on the Audio
page are applied. If Order is set to Post (default setting), the Level
and Pan settings of the main output also affect the signals sent to
the auxiliary outputs.
Audio Routing, Remote Control, and Macro Controls
Audio Routing in MASCHINE
MASCHINE MIKRO - Manual - 422
To Next Page
Need help?
General
