Native Instruments Maschine MIKRO User Manual

Note that any events for that Sound in the current Pattern will remain. As a conse-
quence, your recording might directly start to play at the pitch defined by the existing
events!
14.2.4 Arming, Starting, and Stopping the Recording on Your Controller
Starting and stopping the recording.
►
Press F1 (START) to arm the recording.
After the recording has been armed, its behavior will depend on the recording mode you have
selected (via the MODE selector, see section ↑14.2.2, Selecting the Source and the Recording
Mode above):
▪ When recording in Sync mode:
◦ The recording will start at the next bar. Until then the F1 button flashes and a WAIT-
ING FOR NEXT BAR… message appears at the bottom of the display.
◦ Once the recording has started, the audio is recorded for the duration set by the
LENGTH control (see section ↑14.2.2, Selecting the Source and the Recording Mode
above). You can also press F1 (STOP) beforehand to stop the recording at the next
bar, or F2 (CANCEL) to cancel the recording (in that case the recorded audio will not
be saved).
▪ When recording in Detect mode:
◦ The recording will start as soon as the input signal exceeds the THRESHOLD value.
Until then the F1 button flashes and a WAITING FOR INPUT… message appears at
the bottom of the display. During this waiting phase you can also start the recording
manually by pressing F1 or cancel the recording by pressing F2 (CANCEL).
Sampling and Sample Mapping
Recording a Sample
MASCHINE MIKRO - Manual - 768

Native Instruments Maschine MIKRO Specifications

General

Brand	Native Instruments
Model	Maschine MIKRO
Category	Telephone
Language	English