EasyManuals Logo
Home>Notifier>Fire Alarms>AM2020

Notifier AM2020 User Manual

Notifier AM2020
268 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #238 background imageLoading...
Page #238 background image
4-24
Security 15088:J 10/22/99
2. Zone to Which All Instant Security Modules
Are Mapped
Zone: Zaa*
Type ID: FZON
Control-By-Event: ( )
Custom Label: Instant Group
Annunciator: No (Not Required).
3. Zone Activated Upon Arming System
Zone: Zab*
Type ID: FZON
Control-By-Event: ( )
Custom Label: Arming Zone
Annunciator: Yes
Annunciator Point: ArrP1
4. Zone Activated When Entry/Exit Door Is
Open
Zone: Zac*
Type ID: FZON
Control-By-Event: ( )
Custom Label: Tenant A Entry/Exit
Annunciator: No (Not required).
5. Zone Activated When Any Instant Module Is Vi-
olated and the System Is Armed
Zone: Zad*
Type ID: RZON
Control-By-Event: AND(Zaa* Zab*)
Custom Label: Installer Specified.
Annunciator: No (Not required).
6. Zone Active for 30 Sec., 30 Sec. After Opening
Entry/Exit Door (Not Dependent on Door Clo-
sure)
Zone: Zae*
Type ID: RZON
Control-By-Event: SDEL(00.00.30 00.00.30 (Zac*))
Custom Label: Installer Specified.
Annunciator: No (Not required).
7. Zone Active 1 Min. After Entry/Exit Door Is
Opened and Left Open
Zone: Zaf*
Type ID: RZON
Control-By-Event: DEL(00.01.00 (Zac*))
Custom Label: Installer Specified.
Annunciator: No (Not required).
Protected Premises Unit (Slave)
Group Interface MM
Annunciator Point: AssPp**
Type ID: AMON
NIB-96
NIB-96 Network Interface Board (continued)
Point
p**
Central Station (Master)
Monitor Module Point (PPU Security Alarm
Input)
Address: LXXMYY
Type ID: SARM
Control-By-Event: (Installer Specified)
Custom Label: Installer Specified.
Tracking: Yes - Security alarm
conditions will restore automat-
ically at the Central Station af-
ter restoral at the Protected
Premises.
No - Security alarm conditions
will latch in the Central Station
until reset at the Central Station
and the Protected Premises
Unit if the NIB-96 has been
configured to prevent reset
from the Central Station - short
condition only.
Annunciator: No (Not required).
**Indicates installer-specified NIB point.
PPU Zone Programming
1. Zone Boundary: Must be less than Zad* and greater than or equal to Zac*.
Figure 1.3-10 Programming Key (continued):
www.PDF-Zoo.com

Table of Contents

Other manuals for Notifier AM2020

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Notifier AM2020 and is the answer not in the manual?

Notifier AM2020 Specifications

General IconGeneral
BrandNotifier
ModelAM2020
CategoryFire Alarms
LanguageEnglish

Related product manuals