SPC Twx Params
215
Page Format
Form Length
Forms length is the number of lines that can be printed on a page.
You can set the form length in inches, millimeters (mm), or as a
function of the current lpi (lines per inch).
Form Width
The form width can be specified in inches, millimeters, or as a
function of the current cpi (characters per inch). The forms width set
should not exceed the actual paper width.
Margins
• Left Margin. Set in columns. Column zero is defined as the far
left edge of the page, and column numbering increments from
left to right.
• Right Margin. Set in columns. Column zero is defined as the
far right edge of the page, and column numbering increments
from right to left.
• Bottom Margin. Defined in lines, starting from line zero at the
bottom of the page and incrementing from the bottom up.
Perforation Skip
• Disable. Allows printing on page perforation.
• You may set up a skip-over margin of 1/2 inch, 2/3 inch,
5/6 inch, or 1 inch. For example, a skip-over margin of 1 inch
allows a 1 inch margin at the bottom of the page.
Print Char. Set
When this selection is displayed and the ENTER key is pressed,
the current character set is printed.
LinePrinter Plus Emulation
To Next Page
Loading...
Need help?
General