5-5
Set Removal
After the genset is disconnected from electrical, ex-
haust and fuel systems, examine the set mounting
and support system. Locate all mounting bolts and
support members for the set. In most installations
the generator housing will be mounted to the coach
framework. Depending on the installation, the set
may be removable from the side, back or bottom.
Verify that the genset is adequately supported be-
fore loosening any of the mounting bolts or support
members. Use a forklift to lift or move the set.
WARNING
The genset is heavy, and can cause
severe personal injury if dropped during remov-
al. Use the recommended removal procedures,
and keep hands and feet clear while removing
mounting bolts. Make certain that all vehicle
systems have been disconnected before per-
forming this procedure.
Park the vehicle on a level surface which can sup-
port the forklift. Move the transmission to PARK,
lock the brakes and remove the ignition key. Do not
move the vehicle during this procedure.
WARNING
Dropping the genset can cause se-
vere personal injury or death. Make sure no one
moves the vehicle during this procedure and
that the procedure is performed very carefully
and only as instructed.
Compartment Mount:
1. Use a forklift to support and move the genset.
2. Make sure that the genset is adequately sup-
ported before removing any of the mounting
bolts.
3. Remove all mounting bolts then slide the gen-
set out of the compartment and onto the forklift.
Slowly lower the genset before moving it to the
service area.
To Next Page
Loading...
Need help?
General
