Orbit Reader 20 – User guide Version 1.8
Orbit Research Confidential and Proprietary Information 55
3. Hold the Power button for at least two seconds. If the unit is on, it should
turn off. If it is off, it should come on.
Option 2: Check SD card
1. Remove the SD card.
2. Hold the Power button for two seconds.
Option 3: Unplug the device
1. If the unit is plugged in, unplug the power cord.
2. Hold the Power button for at least two seconds.
Option 4: Reset device
1. Press the Reset command (Dot 8 + right-bottom Panning key). Note: On
reset, the unit is unresponsive, and there is no change to the display.
2. Hold the Power button for at least two seconds.
Option 5: Remove the battery
Note: Use this option as a last resort.
1. Call customer service for guidance on safely removing the battery.
2. Leave it out for a few minutes.
3. Reconnect it, then try the options again.
If none of the options work and the device does not come on, contact Customer Service at
techsupport@orbitresearch.com.
24 Battery Use and Replacement
The Orbit Reader 20 includes a rechargeable Lithium-ion 3000 mAh capacity
battery. It fully charges in about three hours under optimal conditions. A full
battery charge lasts approximately three days of typical use. You can check
Battery status in the Menu.
When the battery in Orbit Reader 20 gets to 10%, Dot 8 of the 20th cell on the
display starts blinking. This behavior is normal, indicating that the battery is low.
The battery in Orbit Reader 20 should last several years. Gradually, the battery
begins discharging faster than usual. When the amount of time that the battery
holds charge becomes inconvenient, it is time for replacement.
To replace the battery, follow these steps:
To Next Page
Loading...
Need help?
General
