EasyManuals Logo
Home>Orbit>Card Reader>Reader 20

Orbit Reader 20 User Manual

Orbit Reader 20
63 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #63 background imageLoading...
Page #63 background image
Orbit Reader 20 User guide Version 1.8
Orbit Research Confidential and Proprietary Information 63
Your product will be returned to you configured as originally purchased, subject to
applicable updates. You will be responsible for reinstalling all other software programs,
data, and passwords. Recovery and reinstallation of software programs and user data are
not covered under this Limited Warranty.
27.3 Appendix C - FCC Information
FCC Notice
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
FCC Caution
To ensure continued compliance follow the installation instructions and this device must
be installed with a computer or peripheral device certified to comply with Part 15 of the
FCC rules for the Class B limits. Use shielded interface cables only. Use the power
adapter that is supplied with the device to charge its internal battery pack.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Orbit Reader 20 and is the answer not in the manual?

Orbit Reader 20 Specifications

General IconGeneral
BrandOrbit
ModelReader 20
CategoryCard Reader
LanguageEnglish

Related product manuals