156
Integrator Mode
7) Setting component input ★ (applies only when equipped with PDA-5002)
INPUT 1 and 2 handle two kinds of component picture signals.
Set them in accordance with the peripheral devices used.
Make the setting for each input and for each signal in accordance with the following.
For Y Pb Pr input (from HDTV equipments, etc.) = select VIDEO INPUT: COMPONENT1
For Y Cb Cr input (from DVD players, etc.) = select VIDEO INPUT: COMPONENT2
1 Enter integrator mode.
(See 5.4.1, “About the integrator mode.”)
The set ID will be displayed on the upper right where the
“– –“ mark is.
Select SET UP.
2 Move the cursor to VIDEO INPUT and use the SET button
to change the setting.
Each time the SET button is pressed, the setting will change
between COMPONENT1 and COMPONENT2.
Screen 1
Screen 2
Set-able condition : INPUT 1 and 2, during video signal input (other than personal computer signals)
Factory preset : COMPONENT2 for 525i, 525p, 625i and 625p input
COMPONENT1 for 1125i, 1125p and 750p input
]
]
2
EN :
:
:
:
RA
X
2
CE
O
NB
H
T
ETVD
1
:
6
035 i
COMPONE N T
1
0
OFF
OFF
D
H
OEDM
M
IOEVPUTDIN
LVSMEBUUO
U/L
INPUT1
ENTER EXITMENU
SET
SELECT
––
INTEGRATOR MENU
PICTURE WHITE BAL SCREEN SET UP OPTION
2
EN :
:
:
:
RA
X
2
CE
O
NB
H
T
ETVD
1
:
6
035 i
COMPONE N T
1
0
OFF
OFF
D
H
OEDM
M
IOEVPUTDIN
LVSMEBUUO
U/L
INPUT1
CHANGE EXITMENU
SET
SELECT
––
INTEGRATOR MENU
PICTURE WHITE BAL SCREEN SET UP OPTION
To Next Page
Loading...
Need help?
General