161
Integrator Mode
11) Setting OFF TIMER
This function is designed to switch the plasma display into standby mode after a selected time has elapsed. In
addition, the full mask function can be automatically implemented prior to entering the standby mode.
For example, if the settings are made as follows,
TIMER: ON
DISPLAY TIME: 10H
MASK TIME: 2.5H
MASK COLOR: WHITE
then after 10 hours of normal operation, a mask will be displayed (white) for 2.5 hours. Then, standby status will go
into effect. (At this time, the power supply will remain on for last memory.)
Factory preset : TIMER: OFF
DISPLAY TIME: 1H
MASK TIME: 0.0H
MASK COLOR: WHITE
1 Enter integrator mode.
(See 5.4.1, “About the integrator mode.”)
The set ID will be displayed on the upper right where the
“– –“ mark is.
Select OFF TIMER under OPTION.
2 Select the item and use the 2 and 3 buttons to change the
setting.
The TIMER setting will switch between OFF and ON.
DISPLAY TIME will change in one-hour increments, between
1 and 24H, as follows: ··· Ô 1H Ô 2H Ô ··· Ô 24H Ô 1H···
MASK TIME will change in half-hour increments, between
0.0 and 9.5H, as follows: ··· Ô 0.0H Ô 0.5H Ô ··· Ô 9.5H
Ô 0.0H Ô ···
MASK COLOR will change as follows: ··· Ô WHITE Ô RED
Ô GREEN Ô BLUE Ô ···
Press the SET button to retun to screen 1.
OFF TIMER is available for all inputs.
(Note) During display of the OFF TIMER mask, AUTO
POWER OFF and POWER MANAGEMENT
functions do not operate.
Screen 1
Screen 2
]
]
O
D:
:
:
:
:
:
:
:
:
AA
SD
E
M
T
T
B
O
U
R
NO
FF
OFF
OF/F
OFF
OFF
ON
E
R
LUAKSF
S
L
E
I
DI
M
AKSM
OEDM
OEDM
OEDMOEDM
AKSMLOT
E
N
TO
R
I
O
BRR
C
ENSE
R
I
C
V
OLO
R
48
B
00
128
/
1
1
28 128
/
1
0
/
0
.W/
PS
INPUT1
––
INTEGRATOR MENU
ENTER EXITMENU
SET
SELECT
PICTURE WHITE BAL SCREEN SET UP OPTION
KAC
:
MS
KAMS
PIDS
RLOO W EI
H
H
00
.
1
H
T
FOTIME
TIME
:
OFF
:
:
TIM
LAY
E
RF
TIMER
CHANGE
EXIT
SET
MENU
SET
SELECT
To Next Page
Loading...
Need help?
General