Polaris Sportsman 400 User Manual

TRANSMISSION
8.5
GEAR SHIFT SELECTOR INSTALLATION
1. Place gear shift selector back into the mounting
bracket and replace five bolts.
2. Reconnect linkage rods to gear shift selector
slides. Adjust as required. See linkage
adjustment procedures.
3. Replace remaining parts.
BOOT REPLACEMENT
NOTE: If moisture is found in thegear shift selector
the boot should be replaced.
1. Using a slotted screwdriver, remove cap from
gear shift knob.
2. Remove torx screw securing knob to selector
rod.
3. Pull selector knob off selector rod.
4. Remove band clamp on rubber boot.
5. Slide boot off selector rod and replace with a
new one.
6. Apply RTV silicone to selector rod to seal top of
boot.
7. Place band clamp in position and tighten using
CV boot clamp pliers.
8. Replace shift knob, securing it to selector rod
withscrewremovedinstep2.
9. Push shift knob cover back into place. Allow
approximately12hoursforRTVsiliconetocure.
Knob
Screw
Cap
Clamp
Boot
Seal with
RTV silicone

Polaris Sportsman 400 Specifications

General

Brand	Polaris
Model	Sportsman 400
Category	Offroad Vehicle
Language	English