MAINTENANCE
2.25
RECOIL HOUSING
S Drain the housing periodically to remove moisture.
S Drain the recoil housing after operating the ATV in
very wetconditions. This shouldalsobe donebefore
storingtheATV. Thedrainscrewislocatedatthebot-
tom of the recoil housing. Remove the screw with a
10mm wrench. Reinstall screw once housing has
been drained.
S CAUTION: Makesurethemanualstart handle isful-
ly seated on therecoil housing, especially when trav-
elling in wet areas. If it is not sealed properly, water
may enter the recoil housing and damage compo-
nents.
S Waterwillentertherecoilhousingifthestarterhandle
isdisengagedfrom theropeguidewhenunderwater .
S After travelling in wet areas the recoil housing and
starter should always be drained completely by re-
moving the recoil.
S Do not open the crankcase drain unless the engine
has ingested water. Some engine oil will be lost if
crankcase drain is opened.
S If recoil handle seal has been damaged, the handle
shopuld be replaced.
Recoil Drain (above front
propshaft)
Crankcase Drain
To Next Page
Loading...
Need help?
General
