ELECTRICAL
10.2
HIGH BEAM HEADLIGHT ADJUSTMENT
The headlight beam can be adjusted to any position desired by turning the adjusting knob located on the bottom
right side of the headlight pod.
1. Place the vehicle on a level surface with the headlight
approximately 25’ (7.6 m) from a wall.
2. Measure the distance from the floor to the center of the
headlightandmakeamarkonthewallatthesameheight.
3. Start the engine and turn the headlight switch to high
beam.
4. Observe headlight aim. The most intense part of the
headlight beam should be aimed 2″ (5.1 cm) below the
mark placed on the wall in step 2 NOTE: Rider weight
must beincludedontheseat. Onmachines withseparate
low beam lights, the drop should be 8″ (20.3 cm) in 25’
from the center of the low beam lamp.
5. Adjust beam to desired position .
HIGH BEAM HEADLIGHT LAMP REPLACEMENT
CAUTION: Do not service
while headlight is hot. Serious
burns may result.
1. RemovethreePhillipsscrews
at back of headlight pod.
2. Remove Phillips screws from
bottom of headlight pod at
each front corner . NOTE: To
aid in accessing these
screws, it may be helpful to
turn handlebars to left or right
and use a short, stubby
screwdriver. Removal of the
front rack and cover will also
allow easier access.
3. Lift pod cover up.
4. Unplug headlamp from wiring
harness.
5. Remove rubber shield from
headlamp housing.
6. Push in and turn plastic re-
tainer counter clockwise and
remove.
7. Carefully remove headlamp
bulb from housing.
8. Reverse procedure to install
new headlamp bulb.
25’ (7.6 m)
Lamp Center Height
2″ (5.1 cm)
Snap pins
into tabs
Position
knob in
slot and
secure
in lock-
ing tabs
Slip O-Ring
over pin
Adjustment
Knob Stop
Route
plug over
handlebar
To Next Page
Loading...
Need help?
General
