Installation
11
5 Installation
Follow the instructions below for indoor and outdoor installation of the Quasar PTZ series of
cameras.
5.1 Indoor Installation
This section applies to the following cameras:
CP-3211-180
CP-4221-200
Read the instructions provided in this chapter thoroughly before installing the camera. Following are
additional considerations for indoor installation:
There must be a fuse or circuit breaker at the starting point of the electrical wiring
infrastructure.
For indoor installations, such as industrial applications, the camera must be protected from
hostile external elements (e.g. corrosive environment, metallic dust, extreme temperatures,
soot, moisture, over spray, etc.)
Do not place the camera on or near radiators and heat sources.
All electrical work must be performed in accordance with local regulatory requirements.
5.2 Outdoor Installation
This section applies to the following cameras:
CP-3211-181
CP-3211-181-HPoE
CP-4221-201
CP-4221-201-HPoE
CP-4221-301-HPOE
Read the instructions provided in this chapter thoroughly before installing the camera. Following are
additional considerations for outdoor installation:
For outside wiring installation, always use weatherproof equipment, such as boxes,
receptacles, connectors, etc.
For electrical wiring, use the properly rated sheathed cables for conditions to which the
cable will be exposed (for example, moisture, heat, UV, physical requirements, etc.).
Plan ahead to determine where to install infrastructure weatherproof equipment. Whenever
possible, ground components to an outdoor ground.
Use best security practices to design and maintain secured camera access, communications
infrastructure, tamper-proof outdoor boxes, etc.
All electrical work must be performed in accordance with local regulatory requirements.
Related Links
To Next Page
Loading...
Need help?
General