Quasar CP-3211/CP-4221 User and Installation Guide
74
When tampering is detected, event images will be sent to the designated e-mail address.
Specify two e-mail addresses to use from the drop-down menu. Select the number of frames
for the pre-trigger and post-trigger buffers from the drop-down menu of 1-20 frames.
Check the box for Continue image upload if you wish to use this option. To specify the length
of time for the upload, click on this radial button and enter the number of seconds. To
upload during the active trigger, click on this radial button. Finally, select the number of
frames per second from the drop-down menu next to Image Frequency.
o PTZ Function – Check this box to specify the parameters which can be activated from
this screen. From the drop-down menu, select the Preset, Sequence, Auto pan or
Pattern.
From the Function Line text box, enter one of the actions that is displayed in the
Preset Position screen, Sequence set screen, Pattern screen or Auto Pan screen.
Figure 57: Application – PTZ Parameters
o Preset – A Preset position is a predefined camera view that is composed of the
camera's pan, tilt, zoom, and focus settings. Each preset position is numbered and
enables an operator to quickly jump to that specific position in a live view. The camera
also can be programmed to go to a specified preset position in a certain order and
time interval.
Upon selecting Preset, the following option is displayed:
Dwell time – The dwell time is the duration time that the camera remains at a
Preset point. The camera goes to the next Preset point when the dwell time
expires.
To Next Page
Loading...
Need help?
General