Technical Bulletin PAGE: 1/2
Subject: Paper Feed Sub-Unit Drum Stay
From: 1st CP Business Department CP Business Center
Electrical
Transmit/receive
Service manual revision
Retrofit information
DRUM STAY:PAPER
FEED SUB-UNIT:NO.2
PLAIN SHAFT BEARING:
6X10X6
Change: The bearing(s) on the Drum Stay were removed from the stay. The bearings and
the stay are supplied separately as spare parts.
Reason: To increase durability
Note
There are two types of the old stay; one that has two bearings (p/n: D1361327) and
another that only has one bearing (p/n: D1361347). Both types were replaced with
the new stay (p/n: D1361328). See the next page for illustrations.
Important
There is no interchangeability (X/X) between the old stay and the new stay. When
replacing the old stay, make sure to replace it with the new stay and the bearing
together as a set.