Connecting the Machine
20
1
Note
! In [Effective Protocol], check that the protocol you want to use is set to [Active].
! [IEEE 802.11b] and [LAN Type] are displayed when the wireless LAN interface
board is installed. If both Ethernet and wireless LAN (IEEE 802.11b) are con-
nected, the selected interface takes precedence.
! SMTP Server and Fax E-mail Account must be specified in order to use the
send function.
! When POP before SMTP is set to [On], also make setting for Reception Proto-
col and POP3/IMAP4 Settings.
! When SMTP Authentication is set to [On], also make setting for Admin. E-
mail Add.
! E-mail Communication Port and Fax E-mail Account must be specified in or-
der to use the reception function.
! When setting POP before SMTP to [On], check POP3 port number in E-mail
Communication Port.
Reference
p.47 “Interface Settings”
p.53 “File Transfer”
Settings Required to Use E-mail Function
This section lists the settings required for sending e-mail.
Ethernet
This section lists the settings required for sending e-mail with Ethernet cable.
For details about how to specify the settings, see "Interface Setting" and "File
Transfer".
Menu User Tool Setting Requirements
Interface Settings/Network Machine IPv4 Address Necessary
Interface Settings/Network IPv4 Gateway Address Necessary
Interface Settings/Network DNS Configuration As required
Interface Settings/Network DDNS Configuration As required
Interface Settings/Network Domain Name As required
Interface Settings/Network WINS Configuration As required
Interface Settings/Network Effective Protocol Necessary
Interface Settings/Network Ethernet Speed As required
Interface Settings/Network LAN Type Necessary
Interface Settings/Network Permit SNMPv3 Communictn. As required
Interface Settings/Network Host Name As required
To Next Page
Loading...
Need help?
General
