System Settings
50
2
Parallel Interface
This section describes the user tools in the Parallel Interface menu under Inter-
face Settings. [Parallel Interface] is displayed when this machine is installed with
the IEEE 1284 interface board.
" Parallel Timing
Sets the timing for the control signal of the parallel interface.
The default setting is ACK outside.
" Parallel Comm. Speed
Sets the communication speed for the parallel interface.
The default setting is High Speed.
" Selection Signal Status
Sets the level for the select signal of the parallel interface.
The default setting is High.
" Input Prime
Sets whether to validate or invalidate the input prime signal upon reception.
The default setting is Inactive.
" Bidirectional Comm.
Sets the printer's response mode to a status acquisition request when using a
parallel interface.
The default setting is On.
When set to [Off], bidirectional communication function will be disabled, and
the printer driver will not be installed under Windows Auto Detect function.
" Signal Control
Specify how error during printing or sending facsimile from the computer is
to be dealt with.
The default setting is Job Acceptance Priority.
Reference
p.4 “Accessing User Tools”
To Next Page
Loading...
Need help?
General
