Copy Paper
61
7
Note
r When using the bypass tray, we recommend you set the copy paper direction
to L.
r If you load paper of the same size and in the same direction in two or more
trays, the machine automatically shifts to another tray when the tray in use
runs out of paper. This function is called Auto Tray switching. This saves in-
terrupting a copy run to replenish paper even when making a large number
of copies. You can cancel this setting.
Reference
To add paper, see Copy Reference.
To change the paper size, see p.42 “Changing the Paper Size”.
Unusable Paper
CAUTION:
Important
r Do not use any of the following kinds of paper or a fault might occur:
• Art paper
• Aluminum foil
• Carbon paper
•Conductive paper
r Do not use copy paper that has been already copied on. Otherwise, a paper
misfeed might occur.
Note
r Do not use any of the following kinds of paper or a misfeed might occur.
• Bent, folded, or creased paper
• Torn paper
• Slippery paper
• Perforated paper
• Rough paper
• Thin paper that has low stiffness
• Paper with a dusty surface
r If you make copies on rough grain paper, the copy image might come out
blurred.
r Do not use paper already copied or printed on.
• Do not use aluminum foil, carbon paper, or similar conductive paper to avoid
a fire or machine failure.
To Next Page
Loading...
Need help?
General
