To Next Page

To Previous Page

File Transfer

This section describes the user tools in the File Transfer menu under System Set-

tings.

Default settings are shown in bold type.

" Delivery Option

Enables or disables sending stored or scanned documents via the ScanRouter

delivery server.

The default setting is Off.

Specify this option when selecting whether or not to use the ScanRouter de-

livery software. If you do, you will have to preregister I/O devices in the

ScanRouter delivery software.

" SMTP Server

Specify the SMTP server name.

Enter server name using up to 127 characters. Spaces cannot be entered.

When using DNS, enter the host name.

When not using DNS, enter the SMTP server IPv4 address.

Enter port number between 1 and 65535 using the number keys, and then

press the {OK} key.

The default setting for Port No. is 25.

" SMTP Authentication

Specify SMTP authentication (PLAIN, LOGIN, CRAMMD5, DIGEST-MD5).

When sending e-mail via an SMTP server, you can enhance the level of SMTP

server security using authentication that requires a user name and password

to be entered.

If the SMTP server requires authentication, set [SMTP Authentication] to [On],

and then specify [User Name], [Password], and [Encrypt].

Enter [User Name] using up to 191 characters. Spaces cannot be entered. De-

pending on the SMTP server type, "realm" must be specified. Add "@" after

the user name, as in "user name@realm".

Enter [Password] using up to 63 characters. Spaces cannot be entered.

Enter the user name and password to be set for [Admin. E-mail Address] when

using Internet Fax.

• Select Encryption as follows:

"Encrypt"-[Auto]: Use if the authentication method is PLAIN, LOGIN,

CRAM-MD5, or DIGEST-MD5.

"Encrypt"-[On]: Use if the authentication method is CRAM-MD5 or DI-

GEST-MD5.

"Encrypt"-[Off]: Use if the authentication method is PLAIN or LOGIN.

The default setting is Off.

Ricoh LD320d User Manual

Other manuals for Ricoh LD320d