3. Projecting Images from a USB
Memory Device or Digital Camera
This chapter explains how to project images from a USB memory device or digital camera.
Requirements for Projecting Images from a
USB Device
• It is recommended to back up the data saved to a USB device before using it. The manufacturer is
not responsible for any damage due to the loss of data.
• Do not disconnect the power plug while the USB device is being accessed. Doing so may cause
malfunction or data loss.
• The USB devices must support USB 2.0.
• The projector supports FAT16 or FAT32 format USB devices. Other forms of USB device are not
compatible.
The projector can project still images and videos stored on a USB memory device or a digital camera.
The following still images and videos are supported by the projector:
Still images
Item Requirement
File extensions jpg, jpeg, JPG, JPEG
File size Less than 10 MB
Number of pixels 2 × 2 to 5120 × 5120 pixels
File format Baseline format
Videos
Item Requirement
File extensions mpg, mpeg, MPG, MPEG, m2ts, m2t, M2TS, M2T
File size Less than 2 GB (FAT16) or 4 GB (FAT32)
Number of pixels 320 × 240 to 1280 × 720 pixels
Video compression format MPEG2
51
To Next Page
Loading...
Need help?
General
