Siemens SINAMICS V20 User Manual

SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
139
Commissioning via the SINAMICS V20 Smart
Access
6
Using the optional SINAMICS V20 Smart Access (Page 400) to commission the converter
provides you with a smart commissioning solution.
SINAMICS V20 Smart Access is a Web server module with integrated Wi-Fi connectivity. It
allows Web-based access to the converter from a connected device (conventional PC with
wireless network adapter installed, tablet or smart phone).
Note
To avoid any unauthorized Web access, use the SINAMICS V20 Smart Access with the
converter only when you perform the Web
-based converter commissioning.
Note
To use SINAMICS V20 Smart Access to con
trol the converter, the supported converter
firmware version must be 3.93 or later.
With SINAMICS V20 Smart Access, you can easily perform the following operations via Web
access to the converter:
● Quick converter commissioning (Page 150)
● Converter parameterization (Page 155)
● Motor operation in JOG/HAND mode (Page 160)
● Converter status monitoring (Page 163)
● Fault/alarm diagnostics (Page 163)
● Data backup and restore (Page 166)

Siemens SINAMICS V20 Specifications

General

Power Range	0.12 kW to 30 kW
Overload Capacity	150% for 60 seconds
Protection Class	IP20
Storage Temperature Range	-40°C to +70°C
Altitude	Up to 1000 m without derating
Input Voltage	3AC 380 V to 480 V
Output Voltage	0 V to Input Voltage
Control Modes	V/f control
Ambient Temperature Range	-10°C to +60°C
Relative Humidity	5% to 95%, non-condensing
Communication Interfaces	Modbus RTU
Braking Resistor	Optional external