Siemens SINAMICS V20 User Manual

Electrical installation
SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
35
Electrical installation
4
Third-party motors that can be operated
You can use the converter to operate standard asynchronous motors from other
manufacturers.
NOTICE
Motor damage due to the use of an unsuitable third-party motor
A higher load occurs on the motor insulation in converter mode than with mains operation.
Damage to the motor winding may occur as a result.
• Please observe the notes in the System Manual "Requirements for third-party motors"
Additional information is provided on the Internet: Requirements for third-party motors
(https://support.industry.siemens.com/cs/ww/en/view/79690594)

Siemens SINAMICS V20 Specifications

General

Power Range	0.12 kW to 30 kW
Overload Capacity	150% for 60 seconds
Protection Class	IP20
Storage Temperature Range	-40°C to +70°C
Altitude	Up to 1000 m without derating
Input Voltage	3AC 380 V to 480 V
Output Voltage	0 V to Input Voltage
Control Modes	V/f control
Ambient Temperature Range	-10°C to +60°C
Relative Humidity	5% to 95%, non-condensing
Communication Interfaces	Modbus RTU
Braking Resistor	Optional external