WORKSHOP MANUAL
EDITION
PAGE
12 /
124
Check that the steering chain is sufficiently tight and adjust it if necessary.
Carry out a general inspection of the machine, asking yourself these last questions:
– Is the machine clean?
– Is there any oil leakage?
– Is there any abnormal noise or rattling?
Fill in the warranty certificate to guarantee that the delivery service has been carried out and per-
formed correctly.
Make sure that the client has received all the documentation when the machine is picked up or
delivered.
Pay utmost attention when loading the machine on or off a trailer or truck, in particular:
• Load the machine with the equipment (if present) in the “Transport” position, making sure not to
hit the ramps while climbing.
• Use ramps of adequate strength and length for the means of transport on which the machine
has to be loaded.
• During transport, engage the parking brake and place the equipment (if present) on the ground
because any violent jolts could break the frame of the cutting deck.
• Use the metal parts of the machine frame as gripping points to secure it to the means of trans-
port.
• Make sure the machine cannot move during transport.
• DO NOT fix the machine to elements of the means of transport which do not offer the necessary
strength, or which could be damaged in the event of impact or jolts.
The machine must never be lifted by means of a hoist or other means of
lifting involving ropes.
For all the operations involving the partial lifting of the machine, the cutting deck or
other front equipment present must be removed.
To Next Page
Loading...
Need help?
General
