WORKSHOP MANUAL
EDITION
PAGE
22 /
124
If one of the above conditions does not occur, check the operation of the safety micros-
witches, simulating the different situations of use as indicated in the specific chapter
.
Check the pressure and adjust if necessary. The recommended air pressure is indicated on the
footboard mat.
See the “Instructions for use” supplied with the machine and the engine manufacturer's manual.
See the “Instructions for use” supplied with the machine and the engine manufacturer's manual.
For the description of the interventions, see the chapters “Wheels-Transmission-Brake”
and “Hydraulic system”
of this manual.
Check the condition of all the belts and the efficiency of the tensioners.
See chapter “Steering” of this manual.
See the “Instructions for use” supplied with the machine and the engine manufacturer's manual.
Remove the protective covers from the engine and clean between the cooling tabs. Use a
brush and compressed air. Check the engine Manufacturer’s Manual.
Remove the spark plug (or spark plugs) and clean them or replace them if necessary. Check the
engine Manufacturer’s Manual.
Check the engine Manufacturer’s Manual.
Lubricate the articulation point (4 lubricators) and all the parts indicated in the appropriate section
of this manual.
Check that there are no abnormal noises.
To Next Page
Loading...
Need help?
General
