Field or control Description
IP Protocol Sets the IP protocol pattern for which to search.
Tap a Binary or Hex field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values.
Only available when Mark On = IP Header.
Source, Destination Address Sets the source and/or destination IP address pattern for which to search.
Tap a Hex or Decimal field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values.
Only available when Mark On = IP Header.
Source Port, Destination
Port
Sets the source and/or destination TCP header port pattern for which to search.
Tap a Binary, Hex or Decimal field and use the A and B knobs to select and change the
values. Or double-tap on the field and use the virtual keypad to enter values.
Only available when Mark On = TCP Header.
Sequence Number Sets the TCP header sequence number pattern for which to search.
Tap a Binary, Hex or Decimal field and use the A and B knobs to select and change the
values. Or double-tap on the field and use the virtual keypad to enter values.
Only available when Mark On = TCP Header.
Ack Number Sets the TCP header ack number pattern for which to search.
Tap a Binary, Hex or Decimal field and use the A and B knobs to select and change the
values. Or double-tap on the field and use the virtual keypad to enter values.
Only available when Mark On = TCP Header.
Data Bytes Sets the number of client data bytes for which to search (one to sixteen bytes). Use the A knob
to change the value.
Only available when Mark On = Client Data.
Byte Offset Sets the client data byte offset (Don't Care or the number of bytes). Tap the field and use the A
knob to change the value.
Only available when Mark On = Client Data.
Client Data Sets the data pattern for which to search. The number of bits shown depends on the Data
Bytes setting. Use in conjunction with the Mark When field to specify the exact search
condition.
Tap the Binary, Hex or ASCII field and use the A and B knobs to select and change the values.
Or double-tap on the field and use the virtual keypad to enter values.
Only available when Mark On = Client Data.
Menus and dialog boxes
236 MSO54, MSO56, MSO58, MSO58LP, MSO64 Help
To Next Page
Loading...
Need help?
General
