Security configuration menu fields and controls.
Field or control Description
USB Ports Tap to enable (On) or disable (Off) all USB ports (Device and Host).
LAN Port Tap to enable (On) or disable (Off) the Ethernet port.
Firmware Updates Tap to enable (On) or disable (Off) the ability to update the oscilloscope firmware.
Set Password Opens the Set Password menu.
Change Password Opens the Change Password menu.
TekSecure Erase Memory Tap Run TekSecure to erase nonvolatile memory. It will take approximately seven minutes to
erase the memory.
NOTE. You cannot stop the TekSecure process once it is started.
NOTE. Do not power down the instrument while TekSecure is running.
NOTE. Save any important waveform, screen capture, instrument setup, report, and session
files to external memory before running TekSecure.
NOTE. TekSecure does not erase calibration constants or instrument firmware.
Passwords and sending the instrument for service. If you need to send the instrument for service or repair, make sure to use
the Clear Password function in the Change Password menu before sending to the Tektronix Service Center. Failure to do so
may impede servicing the instrument.
Enter Password configuration menu (optional)
Use this function to enter the password to access optional security functions. This menu is only shown on instruments with the
optional security function installed.
To enter the password to allow changing the selected security feature state (On or Off):
1. Tap Utility in the Menu bar.
2. Tap Security.
3. Tap the button of a function that you want to change, to open the Enter Password menu.
4. Enter the password and tap OK. The menu closes and toggles the selected function's button state.
Menus and dialog boxes
300 MSO54, MSO56, MSO58, MSO58LP, MSO64 Help
To Next Page
Loading...
Need help?
General
