Tektronix MSO58 Printable Help

Bus Trigger configuration
Use the Bus trigger menus to trigger on bus-related events (Start, Stop, Missing Ack, Address, Data, and so on).
NOTE. You must add a bus to the Waveform view before you can trigger on it. Add a math, reference, or bus waveform on
page 93.
To open the Bus trigger menu:
1. Double-tap the Trigger badge on the Settings bar.
2. Set the Trigger Type to Bus.
3. Select the bus on which to trigger in the Source field.
Use the following links to access trigger settings for specific buses.
ARINC 429 serial bus trigger settings panel on page 343
Audio serial bus trigger settings panel on page 346
CAN serial bus trigger settings panel on page 348
Ethernet serial bus trigger settings panel on page 350
FlexRay serial bus trigger settings panel on page 353
I2C serial bus trigger settings panel on page 356
LIN serial bus trigger settings panel on page 358
MIL-STD-1553 serial bus trigger settings panel on page 360
Parallel serial bus trigger settings panel on page 363
RS-232 serial bus trigger settings panel on page 365
SENT serial bus trigger settings panel on page 367
SPI serial bus trigger settings panel on page 370
SPMI serial bus trigger settings panel on page 372
USB serial bus trigger settings panel on page 375
Other trigger types.
■
Edge Trigger menu
■
Logic Trigger
■
Pulse Width Trigger menu
■
Rise/Fall Time Trigger menu
■
Runt Trigger menu
■
Sequence Trigger menu
■
Setup & Hold Trigger menu
■
Timeout Trigger menu
■
Window Trigger menu
Menus and dialog boxes
342 MSO54, MSO56, MSO58, MSO58LP, MSO64 Help

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English